DeWalt 10" Jobsite Table Saw w/ Rolling Stand DWE7491RS Reviews

No loose-blade problem in a year of use and a great saw so far, though others' reports give them pause.

Ended up buying it as a first table saw; with one good planed side it is accurate enough to rip boards for glue-ups.

Previously owned it and found it very stable with no play in the housing, selling it only to get a stiffer top.

Went with it over a Bosch and reports zero regrets after a couple of years, saying it does everything needed and more.

Added a soft start module to their saw and says the wiring instructions worked perfectly; notes the module has an adjustment screw for the softest start.

Everyone who uses their saw loves it; they think the fence problem in the thread is a defective unit.

Four of these in use; the arbor that accepts a dado stack is the biggest perk.

Homeowner and amateur who uses the saw heavily and loves it.

About two years in after a discounted retaped-box purchase, very happy: good power, accurate adjustments and quick setup.

Owner who likes it quite a bit; notes it takes a dado stack, which many small saws cannot, and likes the fence.

Really likes the saw overall, but warns the cast aluminum top is not perfectly flat; the waviness does not seem to matter much in use.

Beginner who bought it on sale and feels it was worth the price; praises the warranty, solid build and especially the easy, accurate rack and pinion fence.

Loves the rack and pinion fence on their own saw.

The rack and pinion fence is the best they have used, and it stayed dead on square six months after they set it.

Handles both job site work and finer work well; long boards and large flat sheets are a challenge because of the saw size.

A job site workhorse they would buy again, though they now use a cabinet saw for shop work; cuts are fine for plywood with a good feed setup.

After owning both a Ridgid jobsite saw and this one, this is much better, mainly for its fence, though the Ridgid stand is nicer.

Chosen for its dado capability with a highly rated fence; the first unit had a blade alignment defect and the maker replaced it under warranty.

Runs a dado stack on it regularly and rips plywood to full width; values the extra rip capacity and says it suits a cramped workshop.

Upgraded from the smaller 8-1/4 inch saw after a year and likes the 10 inch model more, mainly for sharing blades with a miter saw and wider blade choice. Notes both saws are very loud.