DeWalt 10" Jobsite Table Saw w/ Rolling Stand DWE7491RS Reviews

Came new in a bundle with an XR drill/driver set, and they like it a lot.

Good for ripping trim, moldings and paneling, but large 3/4 inch sheets are awkward because the stand shifts when pushing them.

Talked a used one down to $475; after only brief use making a featherboard they are happy with how it feels.

Found odd wear marks on the stock blade at the first blade change on a saw bought new; unsure whether it is a blade defect or an arbor problem.

Fitted a soft start module to their saw following posted wiring details and reports it works great.

Two separate units developed a loose arbor nut after months of use, with the blade spinning on for a minute after shutoff; they want a refund and a different saw.

No loose-blade problem in a year of use and a great saw so far, though others' reports give them pause.

Seven years of dependable use with a dust collector, but the fence top has tilted out of square with no adjustment and a replacement costs about half the saw price, so they would not buy it again.

Ended up buying it as a first table saw; with one good planed side it is accurate enough to rip boards for glue-ups.

Second-hand purchase a few years ago shows noticeable blade misalignment that follows the arbor; they suspect a bent arbor from its past use.

Cuts thick stock and can be set up accurately without power issues, but it loses that accuracy quickly and is light enough that heavy boards push it around. Still fond of it.

Cutting thick cherry with a thin-kerf blade trips the breaker about four times, though they suspect old-house wiring is partly to blame.

Found the saw fine in general but did not trust it for ripping very thick stock, so used a circular saw and hand saw instead.

Easy to tuck into a shop corner, but they want a better fence with a way to attach featherboards for miter and strip cuts.

Spent four years with it believing their woodworking was off because cuts were never accurate, and the problems vanished on switching to a cabinet saw.

Cuts fine out of the box for cabinets and boxes in plywood, pine and 2x stock, but is not a precision machine and an upgrade to a cabinet saw is planned.

Previously owned it and found it very stable with no play in the housing, selling it only to get a stiffer top.

New saw had play in the motor housing and a blade off parallel after setup, fixed by shimming; support calls and a warranty claim went unanswered, though the saw still cuts well.

Went with it over a Bosch and reports zero regrets after a couple of years, saying it does everything needed and more.

Their saw has the same sagging throat plate lip that catches material; the only workaround found so far is blue tape, which does not always work.